Land Rover Discovery Owners & Service Manuals

Land Rover Discovery: Chassis-Driveline

READ NEXT:

 Driveshaft - Ingenium I4 2.0l Diesel, Vehicles with- active Driveline (G1890848)

 Driveshaft - Ingenium I4 2.0l Diesel, Vehicles with- active Driveline (G1890848) - Removal

PART(S) REMOVAL WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. Refer to: Exhaust System (309-00C Exhaust System - INGENIUM I4 2.0L Diesel, Removal and

 Driveshaft - Ingenium i4 2.0l Diesel, Vehicles with- active Driveline (G1890848) - Installation

Installation Torque: 25 Nm NOTES: Do not tighten at this stage. This step requires the aid of another technician. NOTE: Do not tighten at this stage. NOTES: Do not tighten at this stage.

SEE MORE:

 Electronic Engine Controls - Ingenium i4 2.0l Diesel Post Selective Catalyst Reduction Nox Sensor (G1942280) / Removal and Installation

SPECIAL TOOL(S) REMOVAL WARNING: Observe due care when working near a hot exhaust system. CAUTIONS: The post selective catalyst reduction NOx sensor and module are a single component and cannot be serviced separately. Do not attempt to disconnect the harness from the module, or damage to the

 Body Measurements

Measuring options Comparison measurements can also be made on the outside of the body. Depending on the damage, comparison measurements and diagonal measurements can be carried out using compass, telescopic rod, tape measure or ruler. NOTE: The same reference points must be chosen on both side

© 2019-2026 Copyright www.lrdisc.com