Land Rover Discovery: Driveshaft - Ingenium I4 2.0l Diesel, Vehicles Without- active Driveline (G1890849)
Land Rover Discovery (2009–2016) Service Manual / Chassis / Chassis-Driveline / Driveshaft - Ingenium I4 2.0l Diesel, Vehicles Without- active Driveline
(G1890849)
- Driveshaft - Ingenium I4 2.0l Diesel, Vehicles without- active Driveline (G1890849) - Removal
- Driveshaft - Ingenium I4 2.0l Diesel, Vehicles Without- active Driveline (G1890849) - Installation
Driveshaft - Ingenium i4 2.0l Diesel, Vehicles with- active Driveline
(G1890848) - InstallationDriveshaft - Ingenium I4 2.0l Diesel, Vehicles without- active Driveline
(G1890849) - Removal
READ NEXT:
Driveshaft - Ingenium I4 2.0l Diesel, Vehicles without- active Driveline
(G1890849) - Removal
PART(S)
REMOVAL
NOTE:
Some variation in the illustrations may occur, but the essential
information is always correct.
WARNING:
Make sure to support the vehicle with axle stands.
Raise and support the
Driveshaft - Ingenium I4 2.0l Diesel, Vehicles Without- active Driveline
(G1890849) - Installation
Installation
Torque: 24 Nm
NOTES:
Do not tighten at this stage.
This step requires the aid of another technician.
CAUTION:
The component must be aligned with the installation
markings.
NOTES:
SEE MORE:
Front end Sheet Metal
Repairs Fender
Apron Panel
Front Section (G1775681)
- Installation
Installation
Dress flanges where necessary.
Remove the spot welds from the new fender apron panel as
indicated.
Carefully separate the fender apron panel from the reinforcement.
Mark, measure and cut the new fender apron panel reinforcement
as indicated.
Offer up the new fender apron
Stop / Start Switch
The stop/start switch is located in the Instrument Panel (IP) and is
hardwired
to the Central Junction Box (CJB). When the switch is pressed two signal
lines from the CJB are connected to ground.
AUTO STOP/START WARNING INDICATOR
The auto stop/start warning indicator is located in the Instrumen
© 2019-2026 Copyright www.lrdisc.com
