Land Rover Discovery Owners & Service Manuals

Land Rover Discovery: Rear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion Flange (G1781296)

Land Rover Discovery (2009–2016) Service Manual / Chassis / Chassis-Driveline / Rear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion Flange (G1781296)

next pageRear Drive Axle - Differential - Vehicles with- Active Driveline Differential Support Insulator (G1781301) / Removal and InstallationRear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion Flange (G1781296) - Removalnext page

READ NEXT:

 Rear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion Flange (G1781296) - Removal

SPECIAL TOOL(S) PART(S) REMOVAL NOTE: Some variation in the illustrations may occur, but the essential information is always correct. WARNING: Make sure to support the vehicle with axle stands. R

 Rear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion Flange (G1781296) - Installation

Installation CAUTION: Make sure new bolts are installed. Renew Part: Differential case front bolts. Refer to: Fuel Tank (310-01A Fuel Tank and Lines - TD4 2.2L Diesel, Removal and Installation). Re

 Rear Drive Axle - Differential - Vehicles with- Active Driveline Drive Pinion Seal (G1781297)

SEE MORE:

 Fuel Tank and Lines - Ingenium i4 2.0l Diesel Fuel Tank (G1779692) / Removal and Installation

GENERAL EQUIPMENT Transmission jack REMOVAL WARNINGS: Fuel may still be present in the fuel tank after draining. Place the vehicle in a well ventilated, quarantined area and arrange ' No Smoking/Petrol Fumes' signs about the vehicle. Do not carry or operate cellular phones when working on or

 Engine Emission Control - Ingenium i4 2.0l Diesel Low Pressure Exhaust Gas Recirculation Valve (G1875911) / Removal and Installation

REMOVAL NOTE: Removal steps in this procedure may contain installation details. Refer to: Engine Cover - INGENIUM I4 2.0L Diesel (501-05 Interior Trim and Ornamentation, Removal and Installation). Torque: Clamp 3.5 Nm Bolt 8 Nm NOTE: Remove and discard the O-ring seal. Torque: 12 Nm Torque:

© 2019-2025 Copyright www.lrdisc.com