Land Rover Discovery: Frame and mounting
Land Rover Discovery (2009–2016) Service Manual / Body / Frame and mounting
- Uni-body, Subframe and Mounting System Front Subframe (G2028440)
- Uni-body, Subframe and Mounting System Front Subframe Front Bushing (G1348232) / Removal and installation
- Uni-body, Subframe and Mounting System Rear Subframe - AWD (G1779461)
- Uni-body, Subframe and Mounting System Rear Subframe - FWD (G1799046)
- Uni-body, Subframe and Mounting System Rear Subframe Bushing (G1779466) / Removal and Installation
Exterior Trim and Ornamentation
Tailgate Moulding (G1785266)
/ Removal and InstallationUni-body, Subframe and Mounting
System Front
Subframe (G2028440)
READ NEXT:
Uni-body, Subframe and Mounting
System Front
Subframe (G2028440)
- Removal
SPECIAL TOOL(S)
GENERAL EQUIPMENT
PART(S)
STEP REPLACE PART / RENEW PART PART NAME
Removal
CAUTION:
The final tightening of the suspension components must be carried
out with the vehicle on its
Uni-body, Subframe and Mounting
System Front
Subframe (G2028440)
- Installation
Installation
NOTES:
Steps 1 to 5 must only be performed to the components were
previously removed.
Steps 14 to 20 must be performed to the components on both
sides of the vehicle.
All vehicles
I
SEE MORE:
Starting System - Ingenium
i4 2.0l Diesel / Description
and Operation
COMPONENT LOCATION - SHEET 1 OF 3 - VEHICLES
WITHOUT AUTO STOP/ START SYSTEM
Stop/Start switch
Engine Control Module (ECM)
Starter motor
COMPONENT LOCATION - SHEET 2 OF 3 - VEHICLES WITH AUTO STOP/START SYSTEM - MANUAL TRANSMISSION
Stop/Start switch
Engine Control Module (ECM)
Starter
Third Row Seat
Head Restraint (G1808277)
/ Removal and Installation
REMOVAL
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
Refer to: Third Row Seat (501-10, Removal and Installation).
INSTALLATION
To install, reverse the remova
© 2019-2026 Copyright www.lrdisc.com
