Land Rover Discovery: Exhaust - Ingenium i4 2.0l Diesel Catalytic Converter (G1880489)
Land Rover Discovery (2009–2016) Service Manual / Powertrain / Exhaust System / Exhaust - Ingenium i4 2.0l Diesel Catalytic Converter (G1880489)
- Exhaust - Ingenium i4 2.0l Diesel Catalytic Converter (G1880489) / Removal
- Exhaust - Ingenium i4 2.0l Diesel Catalytic Converter (G1880489) / Installation
READ NEXT:
Exhaust - Ingenium i4 2.0l Diesel Catalytic Converter (G1880489) / Removal
SPECIAL TOOL(S)
PART(S)
REMOVAL
WARNING:
Observe due care when working near a hot exhaust system.
NOTES:
Some variation in the illustrations may occur, but the essential
information is always co
Exhaust - Ingenium i4 2.0l Diesel Catalytic Converter (G1880489) /
Installation
Installation
CAUTIONS:
Make sure the anti-seize compound does not contact the
catalyst monitor sensor tip.
If accidentally dropped or knocked install a new sensor.
Special Tool(s): 310-121
Torq
Exhaust - Ingenium i4 2.0l Diesel Catalytic Converter to Turbocharger Clamp
(G1964846)/ Removal and Installation
REMOVAL
Remove the engine cover.
Refer to: Engine Cover - INGENIUM I4 2.0L Diesel (501-05 Interior
Trim and Ornamentation, Removal and Installation).
Remove the heat shield.
Torque: 10 Nm
Usin
SEE MORE:
Rear Drive Halfshafts
Rear Left
Halfshaft (G1791654) - Installation
Installation
NOTE:
This step is only required if previously removed.
On vehicles without active driveline:
Refer to: Rear Halfshaft Seal (205-02A Rear Drive
Axle/Differential - Vehicles Without: Active Driveline,
Removal and Installation).
On vehicles with active driveline:
Refer to: Rear Hal
Seat Heater Mat
Faults -Diagnostic Guidance
Seat Heater Sensor Faults - Each seat has two heating elements: one in
the base (seat cushion), and one in the back (squab). There is only one
sensor, which is located in the base. This sensor controls both heating
elements. If there is a fault with the sensor signal, neither element will
oper
© 2019-2026 Copyright www.lrdisc.com
