Land Rover Discovery Owners & Service Manuals

Land Rover Discovery: Engine - Ingenium i4 2.0l Diesel Valve Cover (G1875874)

Land Rover Discovery (2009–2016) Service Manual / Powertrain / Engine / Engine - Ingenium i4 2.0l Diesel Valve Cover (G1875874)

next pageEngine - Ingenium i4 2.0l Diesel Upper Timing Cover (G1875872) / Removal and InstallationEngine - Ingenium i4 2.0l Diesel Valve Cover (G1875874) / Removalnext page

READ NEXT:

 Engine - Ingenium i4 2.0l Diesel Valve Cover (G1875874) / Removal

SPECIAL TOOL(S) PART(S) Removal NOTE: Some variation in the illustrations may occur, but the essential information is always correct. Some components shown removed for clarity. Removal steps

 Engine - Ingenium i4 2.0l Diesel Valve Cover (G1875874) /  Installation

Installation All vehicles NOTE: If a new valve cover is installed, new locating dowels must installed. Torque: 47 Nm CAUTION: Install a new seal. Renew Part: Oil fill pipe O-ring seal. Torque: 1

 Engine - Ingenium i4 2.0l Diesel Valves (G1875887) / Removal and Installation

SPECIAL TOOL(S) REMOVAL Refer to: Cylinder Head (303-01B Engine - INGENIUM I4 2.0L Diesel, Removal and Installation). NOTE: Repeat step for other Valves. Using the special tool 303-252 compres

SEE MORE:

 Wheel changing

Before raising the vehicle, refer to all warnings at the beginning of this section of the Owner's Handbook. Before changing a wheel, read and observe the warnings If your vehicle is fitted with side steps or tubes, DO NOT use them as jacking points. Note: Your vehicle may be fitted with a tilt senso

 Engine - Ingenium i4 2.0l Diesel Upper Timing Chain (G1875889) / Installation

 Installation Install the timing chain. CAUTIONS: Make sure the highlighted links on the timing chain are in line with the timing marks as illustrated. Make sure the camshaft pin is located in the VVT unit correctly. Install the VVT unit. Install the bolt, but do not fully tight

© 2019-2026 Copyright www.lrdisc.com