Land Rover Discovery: Engine - Ingenium i4 2.0l Diesel Engine (G1880413) / (G1880415)
Land Rover Discovery (2009–2016) Service Manual / Powertrain / Engine / Engine - Ingenium i4 2.0l Diesel Engine (G1880413) / (G1880415)
- Engine - Ingenium i4 2.0l Diesel Engine (G1880413) Removal
- Engine - Ingenium i4 2.0l Diesel Engine (G1880415) / Installation
Cylinder Head Gasket (G1875895) / InstallationEngine - Ingenium i4 2.0l Diesel Engine (G1880413) Removal
READ NEXT:
Engine - Ingenium i4 2.0l Diesel Engine (G1880413) Removal
REMOVAL
SPECIAL TOOL(S)
GENERAL EQUIPMENT
Engine hoist (1 tonne minimum capacity)
CAUTION:
Make sure that all openings are sealed. Use new blanking caps.
NOTES:
In this procedure the EU6 Exhaust
Engine - Ingenium i4 2.0l Diesel Engine (G1880415) / Installation
INSTALLATION
SPECIAL TOOL(S)
GENERAL EQUIPMENT
Engine hoist (1 tonne minimum capacity)
PART(S)
NOTES:
In this procedure the EU6 Exhaust Gas Recirculation (EGR) assembly
is shown. EU5, EU4 and
SEE MORE:
Rear end Sheet Metal
Repairs Spare
Wheel Well -
Vehicles With- 7 seats (G1770930)
- Installation
Installation
Dress the flanges where necessary.
Offer up the new spare wheel well and clamp into position. Check
alignment, if correct, proceed to next step, if not, rectify and
recheck before proceeding.
Drill holes the where the metal inert gas (MIG) plug welds are to be
installed as in
Exhaust - Ingenium i4 2.0l Diesel Catalytic Converter to Turbocharger Clamp
(G1964846)/ Removal and Installation
REMOVAL
Remove the engine cover.
Refer to: Engine Cover - INGENIUM I4 2.0L Diesel (501-05 Interior
Trim and Ornamentation, Removal and Installation).
Remove the heat shield.
Torque: 10 Nm
Using suitable cutting/grinding equipment remove the clamp weld
at the points illustrated
Remove the
© 2019-2024 Copyright www.lrdisc.com
