Land Rover Discovery: About This Manual
INTRODUCTION
This manual has been written in a format that is designed to meet the needs of technicians worldwide. The objective is to use common formats and include similar content in each manual.
This manual provides general descriptions for accomplishing diagnosis and testing, service and repair work with tested and effective techniques.
Following them will help to ensure reliability.
IMPORTANT SAFETY INSTRUCTIONS
Appropriate service methods and correct repair procedures are essential for the safe, reliable operation of all motor vehicles as well as the personal safety of the individual carrying out the work.
Anyone who departs from the instructions provided in this manual must first establish that personal safety or vehicle integrity is not compromised by the choice of method, tools or components.
WARNINGS , CAUTIONS AND NOTES IN THIS MANUAL
WARNING: Warnings are used to indicate that failure to follow a procedure correctly may result in personal injury.
CAUTION: Cautions are used to indicate that failure to follow a procedure correctly may result in damage to the vehicle or equipment being used.
NOTE: Notes are used to provide additional essential information required to carry out a complete and satisfactory repair.
Generic warnings or cautions are in their relevant description and operation procedure within section 100-00. If the generic warnings or cautions are required for a procedure, there will be a referral to the appropriate description and operation procedure.
If a warning, caution or note only applies to one step, it is placed at the beginning of the specific step.
TRUST MARK AUTHORING STANDARDS ( TAS ) REMOVAL AND INSTALLATION PROCEDURES
NOTE:
TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
A TAS removal and installation procedure uses a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
Many of the TAS procedures will have the installation information within the removal steps. These procedures will have the following note at the beginning of the procedure:
NOTE: Removal steps in this procedure may contain installation details.
Items such as O-ring seals, gaskets, seals, self-locking nuts and bolts are to be discarded and new components installed unless otherwise stated within the procedure. Coated nuts or bolts are to be reused, unless damaged or otherwise stated within the procedure.
Specification procedures will contain all technical data that are not part of a repair procedure.
READ NEXT:
TAS Graphics
Colors used in the graphic are as follows:
Blue - Indicates the target item, item to be removed/installed or
disassembled/assembled
Green and Brown - Indicates a secondary item that needs to be de
TAS Symbols
Symbols are used inside the graphics and in the text area to enhance the
information display. The following paragraphs describe the various types
and categories of symbols.
Prohibition symbols advise
Diesel Fuel System Health and Safety Precautions
DESCRIPTION AND OPERATION
WARNINGS:
Fuel may not give adequate warning before toxic or harmful
effects
arise.
Exposure to fuel can be harmful and can cause severe health
damage or death.
Prov
SEE MORE:
Liftgate Window Glass (G1805065)
- Installation
Installation
CAUTION:
Make sure that the mating faces are clean and free of foreign
material.
NOTE:
Install new spacers.
NOTE:
The tailgate is manufactured from aluminium. Make sure that
appropriate bonding component is applied before the PU
adhesive.
Prepare the window glass, window glass f
Engine - Ingenium i4 2.0l Diesel Valves (G1875887) / Removal and Installation
SPECIAL TOOL(S)
REMOVAL
Refer to: Cylinder Head (303-01B Engine - INGENIUM I4 2.0L
Diesel, Removal and Installation).
NOTE:
Repeat step for other Valves.
Using the special tool 303-252 compress the valve spring. Remove
2 collets from the valve stem using a magnet.
Special Tool(s): 303-252
NO
