Land Rover Discovery: Exterior trim and ornamentation
Land Rover Discovery (2009–2016) Service Manual / Body / Exterior trim and ornamentation
- Exterior Trim and Ornamentation Front Door Lower Moulding (G1796376) / Removal and Installation
- Exterior Trim and Ornamentation Front Fender Trim Panel (G1785263) / Removal and Installation
- Exterior Trim and Ornamentation Rear Door Lower Moulding (G1796253) /Removal and Installation
- Exterior Trim and Ornamentation Rear Spoiler (G1791772)
- Exterior Trim and Ornamentation Rear Wheel Arch Liner (G1817669) / Removal and Installation
- Exterior Trim and Ornamentation Rocker Panel Moulding (G1785265) / Removal and installation
- Exterior Trim and Ornamentation Tailgate Moulding (G1785266) / Removal and Installation
Rear Bumper Cover (G1780371)
/ Removal and
InstallationExterior Trim and Ornamentation
Front Door
Lower Moulding (G1796376)
/ Removal and Installation
READ NEXT:
Exterior Trim and Ornamentation
Front Door
Lower Moulding (G1796376)
/ Removal and Installation
PART(S)
REMOVAL
CAUTION:
Make sure to protect the paintwork.
NOTES:
Removal steps in this procedure may contain installation details.
RH illustration shown, LH is similar.
CAUTION:
Do not use to
Exterior Trim and Ornamentation
Front Fender
Trim Panel (G1785263)
/ Removal and Installation
REMOVAL
CAUTIONS:
Make sure to protect the paintwork.
LH illustration shown, RH is similar.
Using a suitable tool, release the trim panel.
NOTE:
Removal steps in this procedure may contain instal
Exterior Trim and Ornamentation
Rear Door
Lower Moulding (G1796253)
/Removal and Installation
PART(S)
REMOVAL
CAUTION:
Make sure to protect the paintwork.
NOTES:
Removal steps in this procedure may contain installation details.
RH illustration show LH is similar.
CAUTION:
Do not use tools
SEE MORE:
Side Panel Sheet
Metal Repairs 'A'
Pillar
Reinforcement (G1770903) - Installation
Dress the flanges where necessary.
Clean and prepare the panel surfaces.
Using the old A-pillar reinforcement as a guide, detach the new Apillar
reinforcement from the ring frame as indicated.
Separate the joints and remove the A-Pillar reinforcement from the
ring frame.
Cut slots in
Body Closures Liftgate (G1785717)
/ Removal and
Installation
REMOVAL
CAUTION:
Make sure to protect the paintwork.
NOTE:
Some variation in the illustrations may occur, but the essential
information is always correct.
Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
Refer to: Tailgate Mou
© 2019-2026 Copyright www.lrdisc.com
